Home › Drivetrain ยท TL70 MANUAL TRANSMISSION / TRANSAXLE › BACK-UP LIGHT SWITCH

BACK-UP LIGHT SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL BACK-UP LIGHT SWITCH ASSEMBLY
  1. Using a 19 mm union nut wrench, install the back-up light switch assembly with a new gasket to the manual transmission assembly.

    Torque:
    32 N*m{ 329 kgf*cm , 24 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



    C266431E01
  1. In the order indicated in the illustration, engage the 3 clamps in place, and connect the back-up light switch assembly wire and neutral position switch assembly wire.

    HINT:
    Install the wire harness so that there is slack on the connector side.



2. INSTALL MANUAL TRANSMISSION ASSEMBLY
(Click here)