Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (for RHD)

BRAKE MASTER CYLINDER (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL SEAL
  1. Install a new seal to the brake master cylinder sub-assembly.



2. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
  1. Install the brake master cylinder sub-assembly to the brake booster assembly with the 2 nuts.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. Engage the 2 harness clamp.

  1. Using a union nut wrench 12, connect the 2 brake lines and install the brake master cylinder to way tube to the brake master cylinder sub-assembly.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench (Click here).

  1. Connect the reservoir level switch connector.



3. BLEED BRAKE SYSTEM
(Click here)


4. INSTALL FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY RH
(Click here)


5. INSTALL FRONT WHEEL RH

Torque:
120 N*m{ 1224 kgf*cm , 86 ft.*lbf }