Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0122    Lost Communication with Vehicle Dynamics Control Module

DTC    U0416    Invalid Data Received from Vehicle Dynamics Control Module

for Preparation Click here


DESCRIPTION

The power steering ECU assembly receives signals from the ECM and skid control ECU (brake actuator assembly) via the CAN communication system.

DTC Code
DTC Detection Condition
Trouble Area
U0100
Lost communication with the ECM/PCM "A"
  1. CAN communication system
  2. ECM
U0122
Lost communication with the brake system control module
  1. CAN communication system
  2. Skid control ECU (Brake actuator assembly)
U0416
The brake system control module signal malfunction

INSPECTION PROCEDURE

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
  1. Clear the DTC(s) (Click here).

  1. Check for DTCs (Click here).

    OK:
    DTC is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)