Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1522    Motor Circuit Malfunction

DTC    C1523    Motor Circuit Malfunction

DTC    C1524    Motor Circuit Malfunction

DTC    C1555    Motor Relay Welding Failure

for Preparation Click here


DESCRIPTION

The power steering ECU assembly supplies the current to the power steering motor through the motor circuit.

DTC Code
DTC Detection Condition
Trouble Area
C1522
A motor current sensor malfunction
  1. Steering column assembly
  2. Power steering ECU assembly
C1523
An excessively large current deviation
C1524
A short or open in the motor circuit or abnormal voltage or current in the motor circuit
C1555
A motor relay malfunction

WIRING DIAGRAM


C261869E01


INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly or steering column assembly is replaced, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CHECK CONNECTOR CONNECTION CONDITION (POWER STEERING MOTOR - POWER STEERING ECU ASSEMBLY)


    C198234E18
  1. Check the connection condition of the z1 power steering motor connector.

    OK:
    Power steering motor connector is securely connected and locked to the power steering ECU assembly.

    Text in Illustration 
    *a
    Component with harness connected
    (Power Steering ECU Assembly)



NG
CONNECT CONNECTOR SECURELY
OK


2.READ VALUE USING GTS (MOTOR VOLTAGE)
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Start the engine.

  1. Turn the GTS on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the items "Motor Terminal Volt(U)", "Motor Terminal Volt(V)" and "Motor Terminal Volt(W)" in the Data List and read the value displayed on the GTS.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Motor Terminal Volt(U)
    Motor terminal voltage (U phase)/
    Min.: 0.000 V
    Max.: 98.000 V
    Value changes between 4 and 35 V
    The engine is running and the steering wheel is being turned.
    Motor Terminal Volt(V)
    Motor terminal voltage (V phase)/
    Min.: 0.000 V
    Max.: 98.000 V
    Value changes between 4 and 35 V
    The engine is running and the steering wheel is being turned.
    Motor Terminal Volt(W)
    Motor terminal voltage (W phase)/
    Min.: 0.000 V
    Max.: 98.000 V
    Value changes between 4 and 35 V
    The engine is running and the steering wheel is being turned.

    Result 
    Result
    Proceed to
    During steering operation, value changes between 4 and 35 V.
    A
    During steering operation, voltage is not generated or voltage outside specified range is generated.
    B



B
REPLACE STEERING COLUMN ASSEMBLY (Click here)
A

REPLACE POWER STEERING ECU ASSEMBLY (Click here)