Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1528    Motor Rotation Angle Sensor Malfunction

for Preparation Click here


DESCRIPTION

The rotation angle sensor detects the motor rotation angle and sends this information to the power steering ECU assembly.

DTC Code
DTC Detection Condition
Trouble Area
C1528
A rotation angle sensor malfunction
  1. Rotation angle sensor (built into steering column assembly)
  2. Power steering ECU assembly

WIRING DIAGRAM


C261870E01


INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly or steering column assembly is replaced, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CHECK CONNECTOR CONNECTION CONDITION (ROTATION ANGLE SENSOR - POWER STEERING ECU ASSEMBLY)


    C198234E19
  1. Check the connection condition of the z2 rotation angle sensor connector.

    OK:
    Rotation angle sensor connector is securely connected to the power steering ECU assembly.

    Text in Illustration 
    *a
    Component with harness connected
    (Power Steering ECU Assembly)



NG
CONNECT CONNECTOR SECURELY
OK


2.READ VALUE USING GTS (MOTOR ROTATION ANGLE)
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Start the engine.

  1. Turn the GTS on.

  1. Enter the following menus: Chassis / EMPS / Data List.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Motor Rotation Angle
    Motor rotation angle/
    Min.: 0.000 deg
    Max.: 360.000 deg
    Motor rotation angle value changes from 0 to 360°
    The engine is running and the steering wheel is being turned.

    OK:
    During steering operation, motor rotation angle value changes from 0 to 360°.



NG
Go to step 3
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)  

3.CHECK STEERING COLUMN ASSEMBLY


    C264067E01
  1. Disconnect the z2 rotation angle sensor connector from the power steering ECU assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    z2-14 (RZSN) - z2-7 (RZG)
    At 23°C (73°F)
    75.2 to 112.8 Ω
    z2-5 (RZV) - z2-7 (RZG)
    At 23°C (73°F)
    27.6 to 41.4 Ω
    z2-13 (RZCS) - z2-7 (RZG)
    At 23°C (73°F)
    73.6 to 110.4 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Rotation Angle Sensor)



NG
REPLACE STEERING COLUMN ASSEMBLY (Click here)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)