Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1521    Motor Circuit Malfunction

DTC    C1531    ECU Malfunction

DTC    C1532    ECU Malfunction

DTC    C1533    ECU Malfunction

DTC    C1534    ECU Malfunction

DTC    C1554    Power Supply Relay Failure

for Preparation Click here


DESCRIPTION

If the power steering ECU assembly stores these DTCs, it will shut off the power supply relay circuit (built into the power steering ECU assembly) and stop power assist. However, power assist continues if DTC C1533 or C1534 is stored.

DTC Code
DTC Detection Condition
Trouble Area
C1521
Motor overcurrent
Power steering ECU assembly
C1531
An ECU internal malfunction (CPU malfunction)
C1532
An ECU internal malfunction (peripheral circuit malfunction)
C1533
An ECU internal malfunction (substrate temperature sensor malfunction)
C1534
An ECU internal malfunction (EEPROM error)
C1554
A power supply relay circuit malfunction

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly is replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CHECK FOR DTC
  1. Clear the DTC(s) (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
REPLACE POWER STEERING ECU ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)