Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1541    Vehicle Speed Signal Malfunction

for Preparation Click here


DESCRIPTION

The power steering ECU assembly receives vehicle speed signals from the skid control ECU via CAN communication. The power steering ECU assembly provides appropriate assisting force in accordance with the vehicle speed, based on the signals.
If the power steering ECU assembly stores this DTC, it adjusts the amount of power assist to the amount provided for a speed of 100 km/h (62 mph) and continues the system control.

DTC Code
DTC Detection Condition
Trouble Area
C1541
The vehicle speed signals malfunction
  1. Speed sensor circuit
  2. Skid control ECU
  3. CAN communication system
  4. Power steering ECU assembly

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly is replaced with a new one, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Check if DTC U0416 is output (Click here).

    Result 
    Result
    Proceed to
    DTC U0416 is not output.
    A
    DTC U0416 is output.
    B

    HINT:
    DTC U0416 indicates a skid control ECU communication malfunction in the power steering system.



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2.CHECK OTHER DTC OUTPUT (BRAKE CONTROL SYSTEM)
  1. Using the GTS, check for DTCs and confirm that there are no problems in the brake control system (Click here).

    Result 
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
A

REPLACE POWER STEERING ECU ASSEMBLY (Click here)