POWER WINDOW CONTROL SYSTEM > Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch |
| 1.READ VALUE USING GTS |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Master Switch / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| D Door P/W Auto SW | Driver side power window auto switch signal / ON or OFF | ON: Driver side power window auto up/down switch operated OFF: Driver side power window switch not operated | - |
|
| ||||
| OK | |
| 2.PERFORM INITIALIZATION |
Initialize the power window regulator master switch assembly (Click here).
Check that the driver side door power window moves when the auto up and down function of the power window master switch assembly is operated (Click here).
|
| ||||
| OK | ||
| ||
| 3.REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |
Temporarily replace the power window regulator master switch assembly with a new or normally functioning one (Click here).
Check the power window regulator master switch assembly operates (Click here).
| Result | Proceed to |
| Operate | A |
| Does not operate | B |
|
| ||||
| A | ||
| ||