CAN COMMUNICATION SYSTEM > Certification ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Certification ECU Communication Stop Mode | Either condition is met:
|
|


| 1.CHECK FOR OPEN IN CAN BUS LINES (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) BRANCH LINE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the D41 and D48 certification ECU (smart key ECU assembly) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D41-14 (CANH) - D41-15 (CANL) | Cable disconnected from negative (-) battery terminal | 57 to 63 Ω |
| *a | Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D48-11 (GND) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |
| *a | Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly)) |
Connect the cable to the negative (-) battery terminal.
Connect the D41 and D48 certification ECU (smart key ECU assembly) connectors.

Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D41-5 (IG2) - Body ground | Engine switch on (IG) | 11 to 14 V |
| D48-2 (+B) - Body ground | Engine switch off | 11 to 14 V |
| *a | Component with harness connected (Certification ECU (Smart Key ECU Assembly)) |
|
| ||||
| OK | ||
| ||