Home › Power Source / Network › POWER DISTRIBUTION › ELECTRIC POWER CONTROL SYSTEM

DTC    B1011    Battery Power Supply Control Circuit

for Preparation Click here


DESCRIPTION

  1. B1011 is stored when a malfunction is detected in the BMPX circuit.

HINT:
In some cases, none of the functions of the main body ECU (network gateway ECU) may function when B1012 is stored together with B1011.


DTC No.
DTC Detection Condition
Trouble Area
B1011
When BMPX voltage is 8.3 V or less, or 16.7 V or more (BMPX circuit malfunction)
  1. Main body ECU (network gateway ECU)
  2. Instrument panel junction block assembly
  3. Harness or connector

WIRING DIAGRAM


E249070E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1011 is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


3.CHECK HARNESS AND CONNECTOR (BMPX VOLTAGE)
  1. Disconnect the 3C instrument panel junction block assembly connector.



    E249133E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage :
    Tester Connection
    Condition
    Specified Condition
    3C-19 - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Instrument Panel Junction Block Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (ECU GROUND)
  1. Disconnect the D6 and A73 main body ECU (network gateway ECU) connector.

  1. Disconnect the 3B instrument panel junction block assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance :
    Tester Connection
    Condition
    Specified Condition
    D6-1 (GND) - Body ground
    Always
    Below 1 Ω
    A73-4 (GND) - Body ground
    Always
    Below 1 Ω
    3B-18 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
  1. Remove the instrument panel junction block assembly (Click here).



  1. Remove the main body ECU (network gateway ECU) from the instrument panel junction block assembly.


    E249134E01


    Text in Illustration 
    *a
    Component without harness connected
    (Instrument Panel Junction Block Assembly)
    -
    -

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance :

    Tester Connection
    Condition
    Specified Condition
    3C-19 - MB-32 (BMPX)
    Always
    Below 1 Ω
    3B-18 - MB-11 (GND)
    Always
    Below 1 Ω



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK

REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)