Home › Power Source / Network › POWER DISTRIBUTION › ELECTRIC POWER CONTROL SYSTEM

DTC    B1014    ACC Power Supply Circuit

for Preparation Click here


DESCRIPTION

  1. B1014 is stored when a malfunction is detected in the ACC circuit.

DTC No.
DTC Detection Condition
Trouble Area
B1014
When ACC voltage is 8.3 V or less, or 16.7 V or more (ACC circuit malfunction)
  1. Main body ECU (network gateway ECU)
  2. Instrument panel junction block assembly
  3. Harness or connector

WIRING DIAGRAM


E249071E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1014 is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


3.CHECK HARNESS AND CONNECTOR (VOLTAGE)
  1. Disconnect the 3A and 3E instrument panel junction block assembly connector.



    E249136E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    3A-20 - Body ground
    Ignition switch ACC
    11 to 14 V
    3E-1 - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Instrument Panel Junction Block Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (GROUND)
  1. Disconnect the D6 and A73 main body ECU (network gateway ECU) connector.

  1. Disconnect the 3A and 3B instrument panel junction block assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance :
    Tester Connection
    Condition
    Specified Condition
    D6-1 (GND) - Body ground
    Always
    Below 1 Ω
    A73-4 (GND) - Body ground
    Always
    Below 1 Ω
    3A-12 - Body ground
    Always
    Below 1 Ω
    3A-13 - Body ground
    Always
    Below 1 Ω
    3B-18 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
  1. Remove the instrument panel junction block assembly (Click here).



  1. Remove the main body ECU (network gateway ECU) from the instrument panel junction block assembly.


    E249137E02


    Text in Illustration 
    *a
    Component without harness connected
    (Instrument Panel Junction Block Assembly)
    -
    -

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:

    Tester Connection
    Condition
    Specified Condition
    3E-1 - MB-9 (ACC)
    No battery voltage is applied across terminals 3A-20 and 3A-12
    10 kΩ or higher
    3E-1 - MB-9 (ACC)
    Battery voltage is applied across terminals 3A-20 and 3A-12
    Below 1 Ω
    3B-18 - MB-11 (GND)
    Always
    Below 1 Ω



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK

REPLACE MAIN BODY ECU (NETWORK GATEWAY ECU) (Click here)