Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

DTC    B1576    Key Write Malfunction to EFI ECU

for Preparation Click here


DESCRIPTION

The ECM stores this code when an internal malfunction is detected in the ECM, or when the ROM in the ECM cannot be accessed when registering an ECU communication ID.

DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B1576
  1. Internal malfunction in the ECM (1 trip detection logic*).
  2. When the ROM in the ECM cannot be accessed when registering an ECU communication ID (1 trip detection logic*).
ECM
  1. Engine switch on (IG)
  2. Register the ECU communication ID
  1. *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
  1. Engine cannot be started
  2. ECU communication ID cannot be registered
-

Related Data List and Active Test 
DTC Code
Data List and Active Test
B1576
-

INSPECTION PROCEDURE

NOTICE:
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

1.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Refer to Service Bulletin).

  1. Check that the engine can be started.

OK:
The engine can be started.



NG
Go to step 2
OK

END 

2.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Refer to Service Bulletin).

  1. Check that the engine can be started.

OK:
The engine can be started.



NG
Go to step 3
OK

END 

3.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Refer to Service Bulletin).

  1. Check that the engine can be started.

OK:
The engine can be started.



NG
REPLACE ECM (Click here)
OK

END