Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (except LHD M/T)

BRAKE PEDAL (except LHD M/T) > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT SIDE PANEL LH (w/o Knee Airbag)

HINT:
Use the same procedure for the LH side as for the RH side .



2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)


    B312955
  1. Remove the 2 screws.



    B312956
  1. Disengage the 4 clips.

  1. Disengage the 4 claws and separate the No. 1 instrument panel under cover sub-assembly.



    B313000E01
  1. w/ Automatic Air Conditioning System for RHD:

    1. Disengage the guide and disconnect the aspirator hose.

    2. Disconnect the connector.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
    Text in Illustration 
    *1
    Aspirator Hose



3. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


4. REMOVE TCM (for Automatic Transmission)
(Click here)


5. REMOVE STOP LIGHT SWITCH ASSEMBLY
(Click here)


6. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER


    C262296
  1. Disengage the 2 clamps and remove the stop light switch mounting adjuster from the brake pedal support sub-assembly.



7. REMOVE PUSH ROD PIN


    C259963
  1. Remove the clip and the push rod pin from the push rod clevis.



8. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    C256673
  1. Remove the 2 bolts from the brake pedal support assembly.



    C256674
  1. Remove the 4 nuts and the brake pedal support assembly.