FUEL LID LOCK CONTROL CABLE ASSEMBLY (for LHD) > REMOVAL |
| 1. REMOVE FRONT DOOR SCUFF PLATE LH (for LH Side) |
![]() |
Disengage the 6 claws and remove the front door scuff plate LH.
| 2. REMOVE FRONT DOOR SCUFF PLATE RH (for RH Side) |
| 3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
| 4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
| 5. REMOVE FRONT SEAT ASSEMBLY |
| 6. REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY LH |
![]() |
Remove the bolt.
Disengage the hook and remove the separate type rear seat cushion assembly LH.
| 7. REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY RH |
| 8. REMOVE LUGGAGE COMPARTMENT FLOOR MAT |
| 9. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Using a clip remover, remove the 3 clips.
Disengage the 4 claws to remove the rear floor finish plate.
| 10. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER RH |
![]() |
Disengage the 5 clips and remove the luggage compartment inner trim cover RH.
| 11. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH (w/ Side Marker Light) |
![]() |
Disengage the 5 clips.
![]() |
Disconnect the connector and remove the luggage compartment inner trim cover LH.
| 12. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH (w/o Side Marker Light) |
![]() |
Using a clip remover, remove the 5 clips and the luggage compartment inner trim cover LH.
| 13. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH |
![]() |
Pull up the rear seatback assembly.
Remove the clip.
Disengage the 8 clips and remove the luggage compartment trim cover LH.
| 14. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH |
| 15. REMOVE NO. 2 PACKAGE TRAY TRIM SPACER |
![]() |
Using a clip remover, remove the 3 clips and the No. 2 package tray trim spacer.
| 16. REMOVE HANDLE COVER |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw.
| *1 | Protective Tape |
![]() |
Remove the screw.
Remove the handle cover as shown in the illustration.
| 17. REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY |
![]() |
Peel back the floor carpet.
Remove the 2 nuts and the fuel lid lock open lever sub-assembly.
![]() |
Disconnect the fuel lid lock control cable sub-assembly.
| 18. REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY |
![]() |
Remove the fuel lid lock control cable sub-assembly as indicated by the arrows, in the order shown in the illustration.
Using a screwdriver with its tip wrapped in protective tape, disengage the 11 clamps and remove the fuel lid lock control cable sub-assembly.

| *1 | Fuel Lid Lock Control Cable Sub-Assembly | - | - |