Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › TCM

TCM > INSTALLATION

for Preparation Click here



1. INSTALL TCM
  1. for RHD:

    1. Install the TCM bracket to the TCM with the 2 nuts.

      Torque:
      7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    2. Install the 2 bolts and the TCM.

      Torque:
      18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    3. Connect the 2 connectors.

  1. for LHD:

    1. Install the TCM bracket to the TCM with the 2 nuts.

      Torque:
      7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    2. Install the 2 nuts and the TCM.

      Torque:
      7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    3. Connect the 2 connectors.



2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD without Driver Side Knee Airbag)
  1. Connect each connector.



    B312545E01
  1. for Automatic Air Conditioning System for RHD:

    1. Connect the connector.

    2. Engage the guide and connect the aspirator hose.
      Text in Illustration 
      *1
      Aspirator Hose

  1. Engage the 4 claws.

  1. Engage the 4 clips to install the No. 1 instrument panel under cover sub-assembly.

  1. Install the 2 screws.



4. INSTALL INSTRUMENT SIDE PANEL LH (for LHD without Driver Side Knee Airbag)

HINT:
Use the same procedure as for the RH side.



5. RESET CHECK RESET MEMORY
(Click here)

HINT:
When the automatic transmission assembly, transmission valve body assembly, and TCM are replaced, the TCM learning value must be cleared.