Home › Steering › STEERING COLUMN › STEERING PAD SWITCH

STEERING PAD SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STEERING PAD SWITCH ASSEMBLY
  1. Engage the 4 claws to install the steering pad switch assembly.

  1. Install the 2 screws.

  1. Pass the wire harness over the 2 guides.

  1. Connect the steering pad switch connector to the spiral cable sub-assembly.



2. INSTALL HORN BUTTON ASSEMBLY
(Click here)


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



4. INSPECT SRS WARNING LIGHT
(Click here)