Home › Vehicle Exterior › DOOR / HATCH › FUEL LID LOCK CONTROL CABLE ASSEMBLY (for RHD)

FUEL LID LOCK CONTROL CABLE ASSEMBLY (for RHD) > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure as for the LH side .



2. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
Disconnect the front door opening trim weatherstrip to the extent that allows the removal of the luggage compartment trim cover RH.



3. REMOVE FRONT SEAT ASSEMBLY
(Click here)


4. REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY RH

HINT:
Use the same procedure as for the LH side .



5. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


6. REMOVE REAR FLOOR FINISH PLATE


    B312237
  1. Using a clip remover, remove the 3 clips.

  1. Disengage the 4 claws to remove the rear floor finish plate.



7. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER RH


    B314943
  1. Disengage the 5 clips and remove the luggage compartment inner trim cover RH.



8. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH

HINT:
Use the same procedure as for the LH side .



9. REMOVE NO. 2 PACKAGE TRAY TRIM SPACER


    B310917
  1. Using a clip remover, remove the 3 clips and the No. 2 package tray trim spacer.



10. REMOVE HANDLE COVER


    B310918E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw.
    Text in Illustration 
    *1
    Protective Tape



    B310919
  1. Remove the screw.

  1. Remove the handle cover as shown in the illustration.



11. REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY


    B310920
  1. Peel back the floor carpet.

  1. Remove the 2 nuts and the fuel lid lock open lever sub-assembly.



    B310921
  1. Disconnect the fuel lid lock control cable sub-assembly.



12. REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY


    B310922E01
  1. Remove the fuel filler opening lid lock retainer as indicated by the arrows in the order shown in the illustration.



  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 7 clamps and remove the fuel lid lock control cable sub-assembly.


    B310923E01


    Text in Illustration 
    *1
    Fuel Lid Lock Control Cable Sub-Assembly
    -
    -