Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR FLOOR AIRBAG SENSOR

REAR FLOOR AIRBAG SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here


CAUTION:
Be sure to correctly follow the removal and installation procedures for the rear floor side airbag sensor.



1. CHECK NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)
  1. Perform a diagnostic system check (Click here).



2. CHECK NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
  1. Perform a diagnostic system check (Click here).

  1. Visually check for defects with the No. 2 airbag sensor assembly installed on the vehicle.

    HINT:
    The defects are as follows:

    1. Cracks on the sensor housing
    2. Dents on the sensor housing
    3. Chips on the sensor housing
    4. Cracks or other damage to the connector
    5. Damage to the serial number

    OK:
    No defects are found.

    If any of the defects is found, replace the No. 2 airbag sensor assembly with a new one.



3. CHECK NO. 2 AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)
  1. When front seat airbags or curtain shield airbags have deployed as the result of a collision, be sure to replace No. 2 airbag sensor assembly.

  1. Visually check the No. 2 airbag sensor assembly in undamaged areas for defects.

    HINT:
    The defects are as follows:

    1. Cracks on the sensor housing
    2. Dents on the sensor housing
    3. Chips on the sensor housing
    4. Cracks or other damage to the connector
    5. Damage to the serial number

    OK:
    No defects are found.

    If any of the defects is found, replace the No. 2 airbag sensor assembly with a new one.