Home › Brake › PARKING BRAKE › PARKING BRAKE CABLE

PARKING BRAKE CABLE > INSTALLATION

for Preparation Click here



1. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
  1. Install the No. 3 parking brake cable assembly to the parking brake plate with the clamp.

  1. Install the No. 3 parking brake cable assembly to the body with the 4 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



2. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY

HINT:
Use the same procedure for the No. 2 parking brake cable assembly as for the No. 3 parking brake cable assembly.



3. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
(Click here)


4. INSTALL CENTER EXHAUST PIPE ASSEMBLY
  1. Install the center exhaust pipe assembly with the cushion rubber.

  1. Install the new gasket and the center exhaust pipe assembly with the 2 new nuts and the 2 bolts to tail exhaust pipe assembly.

    Torque:
    48 N*m{ 490 kgf*cm , 35 ft.*lbf }

    HINT:
    1. Do not reuse the gaskets.
    2. Do not reuse the nuts.

  1. Install the new gasket and the front exhaust pipe assembly with the 2 nuts and the 2 bolts and the 2 compression springs to the center exhaust pipe assembly.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    HINT:
    Do not reuse the gaskets.



5. INSTALL NO. 2 FUEL TANK PROTECTOR (for Clamp Type)
  1. Install the No. 2 fuel tank protector with 2 new nuts and 2 clips.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



6. INSTALL NO. 1 FUEL TANK PROTECTOR (for Clamp Type)
  1. Install the No. 1 fuel tank protector with 2 new nuts and 2 clips.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



7. INSTALL NO. 3 FUEL TANK PROTECTOR (for Metal Type)
  1. Install the No. 3 fuel tank protector with a new nut and 2 clips.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



8. INSTALL LOWER CASING BRACKET
  1. Install the lower casing bracket of the body with the 2 bolts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



9. INSTALL CLAMP H/B
  1. Install the clamp H/B of the casing lower bracket with the 2 nuts.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



10. INSTALL PARKING BRAKE ASSEMBLY
(Click here)


11. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY
  1. Temporarily install the NO. 1 parking brake cable assembly to the parking brake lever with the adjusting nut.

  1. Install the NO. 2 parking brake cable assembly and NO. 3 to the NO. 1 parking brake cable assembly.



12. INSTALL CONSOLE BOX ASSEMBLY
(Click here)