Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING ECU

HEADLIGHT LEVELING ECU > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicle.



1. REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
(Click here)


2. REMOVE POWER STEERING ECU ASSEMBLY
  1. Install the power steering ECU with the 2 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Engage the clamp.

  1. Connect the 3 connectors to the power steering ECU assembly.



    C260463E01
  1. Connect the connector to the power steering ECU assembly.

    1. As shown in the illustration, return the lock lever to its original position to connect the connector and securely push in the lock of the lock lever.
      Text in Illustration 
      *a
      Return the lock lever
      *b
      Push the lock

  1. Engage the clamp.



3. REMOVE HEADLIGHT LEVELING ECU ASSEMBLY


    B313024
  1. Disconnect the connector.

  1. Remove the nut and headlight leveling ECU assembly.