Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR

HEIGHT CONTROL SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    B309151
  1. Engage the guide as shown in the illustration.

  1. Install the rear height control sensor sub-assembly LH with the 3 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the connector.



2. HEIGHT CONTROL SENSOR SIGNAL INITIALIZATION
(Click here)


3. ADJUST HEADLIGHT AIMING
(Click here)