Home › Power Source / Network › POWER DISTRIBUTION › BATTERY CURRENT SENSOR

BATTERY CURRENT SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

HINT:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with the work (Click here).



2. REMOVE BATTERY CURRENT SENSOR ASSEMBLY


    E247221
  1. Disconnect the connector.



    E247222E01
  1. Remove the nut and disconnect the engine wire.

    NOTICE:
    Since this operation may damage the molding, make sure to fully open the driver and passenger side door windows.

    Text in Illustration 
    *1
    Engine Wire



    E247223
  1. Loosen the nut and remove the battery current sensor assembly.