CENTER AIRBAG SENSOR ASSEMBLY > INSTALLATION |
| 1. INSTALL AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Install the airbag sensor assembly with the bolt and 2 nuts.
| *1 | Waterproof Sheet |
Connect the connectors to the airbag sensor assembly as shown in the illustration.
Check that the waterproof sheet is properly set.
Check that there is no looseness in the installation parts of the airbag sensor assembly.
| 2. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System) |
| 3. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Manual Air Conditioning System) |
| 4. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (w/o Air Conditioning System) |
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 6. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 7. INSPECT SRS WARNING LIGHT |