Home › Engine / Hybrid System › FA20 ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TIMING CHAIN OR BELT COVER OIL SEAL
  1. Apply engine oil to the lip of a new timing chain or belt cover oil seal.

    NOTICE:
    1. Keep the lip free of foreign matter.
    2. Do not apply engine oil to the dust seal section.



    A375976E01
  1. Using SST and a hammer, tap in the timing chain or belt cover oil seal until its surface is flush with the timing chain cover edge.

    SST
    09950-60010   (09951-00460, 09951-00610, 09952-06010)
    09950-70010   (09951-07100)

    NOTICE:
    1. Keep the lip free of foreign matter.
    2. Do not tap the oil seal at an angle.

    HINT:
    Alternatively, the tapping depth of the timing chain or belt cover oil seal can be -1.0 to 0 mm (-0.039 to 0 in.) from the timing chain cover end surface.



2. INSTALL CRANKSHAFT PULLEY
  1. Install the crankshaft pulley spacer.

  1. Install a new O-ring to the crankshaft pulley spacer.



    A302559E01
  1. Install the crankshaft pulley while aligning the knock hole of the pulley with the knock pin on the crankshaft pulley spacer.
    Text in Illustration 
    *1
    Knock Hole
    *2
    Knock Pin



    A302562E01
  1. Install SST to the crankshaft pulley.

    SST
    09213-80010   (90179-10016, 09213-08010, 09213-08110)

    HINT:
    Position the projections on SST in the direction as shown in the illustration to prevent SST from separating from the crankshaft pulley.

    Text in Illustration 
    *1
    Claw

  1. Apply engine oil to the crankshaft pulley set bolt.



    A302563E01
  1. Using SST, hold the crankshaft pulley and tighten the crankshaft pulley set bolt.

    SST
    09213-80010   (90179-10016, 09213-08010, 09213-08110)

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    Text in Illustration 
    *a
    Hold
    *b
    Turn



    A281493E01
  1. Using a marker, draw the reference line (A) on the crankshaft pulley set bolt and also the reference line (B) on the crankshaft pulley according to the line engraved around the crankshaft pulley set bolt head as shown in the illustration.
    Text in Illustration 
    *a
    Reference Line A
    *b
    Reference Line B

    HINT:
    There are carved lines on the crankshaft pulley set bolt head every 90°.



    A302564E01
  1. Using SST, hold the crankshaft pulley, and tighten the crankshaft pulley set bolt by 90° until the reference lines A and B are aligned.

    SST
    09213-80010   (90179-10016, 09213-08010, 09213-08110)
    Text in Illustration 
    *a
    Hold
    *b
    Turn
    *c
    Reference Line A
    *d
    Reference Line B



3. INSTALL FAN AND GENERATOR V BELT
(Click here)