Home › Engine / Hybrid System › FA20 ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE FAN AND GENERATOR V BELT
(Click here)


2. REMOVE CRANKSHAFT PULLEY


    A302560E01
  1. Install SST to the crankshaft pulley.

    SST
    09213-80010   (90179-10016, 09213-08010, 09213-08110)

    HINT:
    Position the projections on SST in the direction as shown in the illustration to prevent SST from separating from the crankshaft pulley.

    Text in Illustration 
    *1
    Claw



    A302561E01
  1. Using SST, hold the crankshaft pulley and loosen the crankshaft pulley set bolt.

    SST
    09213-80010   (90179-10016, 09213-08010, 09213-08110)
    Text in Illustration 
    *a
    Hold
    *b
    Turn

  1. Remove the crankshaft pulley.



    A276039
  1. Remove the O-ring and crankshaft pulley spacer.



3. REMOVE TIMING CHAIN OR BELT COVER OIL SEAL


A276038E01
  1. Using a screwdriver with its tip wrapped in protective tape, pry out the timing chain or belt cover oil seal.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

    HINT:
    Tape the screwdriver tip before use.