Home › Vehicle Exterior › LIGHTING (EXT) › FRONT TURN SIGNAL LIGHT ASSEMBLY

FRONT TURN SIGNAL LIGHT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE FRONT BUMPER COVER
(Click here)


2. REMOVE FOG LIGHT COVER


    B312522
  1. Disengage the 10 claws and remove the fog light cover LH.



3. REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY


    E249682
  1. Remove the 2 nuts.

  1. Disconnect the connector.



    E249683
  1. Disengage the 2 claws to remove the front turn signal light assembly.



4. REMOVE FRONT TURN SIGNAL LIGHT BULB


    E249684
  1. Turn the front turn signal light socket with front turn signal light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

  1. Remove the front turn signal light bulb from the front turn signal light socket and wire.