DOOR CONTROL TRANSMITTER (w/ Entry and Start System) > INSPECTION |
| 1. INSPECT ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY |
Inspect operation of the transmitter.
Remove the transmitter battery (lithium battery) from the transmitter .
![]() |
Install a new or normal battery (lithium battery) (Click here).
| *1 | Dry Cell Batteries |
From outside the vehicle, approximately 1 m (3.28 ft.) away from the driver side outside door handle, test the transmitter by pointing its key plate at the vehicle and pressing a transmitter switch.
Inspect the battery capacity.
Remove the battery from the electrical key transmitter that does not operate.
![]() |
Attach a lead wire (0.60 mm [0.027 in.] in diameter or less including wire sheath) with tape or equivalent to the negative terminal.
| *1 | Lead Wire |
Carefully pull the lead wire out from the position as shown in the illustration and install the previously removed transmitter battery.
![]() |
Measure the voltage of the transmitter battery.
| *a | GND |
| Tester Connection | Condition | Specified Condition |
| Battery positive (+) - Battery negative (-) | Engine switch off, all doors closed and lock sensor touched | 2.2 to 3.2 V |