DOOR CONTROL TRANSMITTER (w/ Entry and Start System) > INSPECTION |
| 1. INSPECT ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY (for Type A) |
Inspect the operation of the electrical key transmitter sub-assembly.
Remove the transmitter battery from the electrical key transmitter sub-assembly .
![]() |
Install a new or normal transmitter battery .
| *1 | Dry Cell Batteries |
From outside the vehicle, approximately 1 m (3.28 ft.) away from the driver side outside door handle, test the electrical key transmitter by pointing its key plate at the vehicle and pressing an electrical key transmitter switch.
Inspect the battery capacity.
Remove the transmitter battery from the electrical key transmitter that does not operate.
![]() |
Attach a lead wire (0.60 mm (0.0236 in.) in diameter or less including wire sheath) with tape or equivalent to the negative terminal.
| *1 | Lead Wire |
![]() |
Carefully pull the lead wire out from the position as shown in the illustration and install the previously removed transmitter battery.
| *a | GND |
Measure the voltage of the transmitter battery.
| Tester Connection | Condition | Specified Condition |
| Transmitter battery positive (+) - Transmitter battery negative (-) | Engine switch off, all doors closed and lock sensor touched | 2.5 to 3.2 V |
| 2. INSPECT TRANSMITTER BATTERY (for Type B) |
Inspect the operation of the electrical key transmitter sub-assembly.
Remove the transmitter battery from the electrical key transmitter sub-assembly .
![]() |
Install a new or normal transmitter battery .
From outside the vehicle, approximately 1 m (3.28 ft.) away from the driver side outside door handle, test the electrical key transmitter by pointing its key plate at the vehicle and pressing an electrical key transmitter switch.
Inspect the battery capacity.
Remove the transmitter battery from the electrical key transmitter that does not operate.
![]() |
Attach a lead wire (0.6 mm (0.0236 in.) in diameter or less including wire sheath) with tape or equivalent to the negative terminal.
| *1 | Lead Wire |
![]() |
Carefully pull the lead wire out from the position shown in the illustration and install the previously removed transmitter battery.
| *a | GND |
Check the transmitter battery voltage.
| Tester Connection | Condition | Specified Condition |
| Transmitter battery positive (+) - Transmitter battery negative (-) | Engine switch off, all doors closed and lock sensor touched | 2.5 to 3.2 V |