Home › Engine / Hybrid System › FA20 ENGINE CONTROL › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL ECM BRACKET
  1. Engage the 2 claws, and install a new ECM bracket to the ECM.

    NOTICE:
    1. After attaching the ECM bracket to the ECM, do not remove the ECM bracket.
    2. If the ECM bracket is attached to the ECM in the incorrect direction, replace the ECM bracket with a new one.



2. INSTALL ECM

NOTICE:
When replacing the ECM, do not use ECM with different specifications.

  1. Install the ECM with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the 4 connectors to the ECM.

    NOTICE:
    Be sure to securely connect the connectors.



3. INSTALL CONTROL UNIT RELAY ASSEMBLY (w/o Entry and Start System)
  1. Install the control unit relay with the bolt.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
  1. Horizontally engage the 2 hinges of the outer glove compartment door.

    NOTICE:
    Make sure to install the glove compartment door assembly hinges horizontally.

  1. Engage the 2 stoppers to install the glove compartment door assembly.

  1. Engage the claw to install the glove compartment door damper.



5. INSTALL INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)
  1. Connect the connector.

  1. Engage the 4 clips and claw to install the instrument side panel RH.



6. INSTALL INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)
  1. Engage the 4 clips and claw to install the instrument side panel RH.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL



8. PERFORM INITIALIZATION

NOTICE:
Perform the following procedure after replacing the ECM, throttle with motor body assembly or any throttle with motor body assembly components.

  1. Turn the ignition switch to ON without operating the accelerator pedal.

    NOTICE:
    If the accelerator pedal is operated, perform the above steps again.

  1. Connect the GTS to the DLC3 and clear the DTCs (Click here).

  1. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range when the A/C is switched off.

    Standard:
    Condition
    Engine Idle Speed
    A/C switched off
    650 to 800 rpm

    NOTICE:
    1. Be sure to perform this step with all accessories off.
    2. Make sure that the shift lever is in neutral (for manual transmission).
    3. Make sure that the shift lever is in N or P (for automatic transmission).

  1. Enter the following menus: Data List / Throttle Sensor Volt%. Fully depress the accelerator pedal and check that the value is 80 to 90%.

  1. Perform a road test and confirm that there are no abnormalities.