Home › Engine / Hybrid System › FA20 ENGINE MECHANICAL › CYLINDER HEAD GASKET

CYLINDER HEAD GASKET > REMOVAL

for Preparation Click here



1. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY RH
(Click here)


2. REMOVE CYLINDER HEAD SUB-ASSEMBLY RH


    A278735E01
  1. Loosen the 6 bolts in the order shown in the illustration.

  1. Lightly tap the cylinder head sub-assembly RH to separate it from the cylinder block (bank 1).

  1. Remove the cylinder head sub-assembly RH.

    NOTICE:
    Be careful not to scratch the mating surface of the cylinder head and cylinder block.



3. REMOVE CYLINDER HEAD GASKET
  1. Remove the cylinder head gasket.



4. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY LH
(Click here)


5. REMOVE CYLINDER HEAD SUB-ASSEMBLY LH


    A278739E01
  1. Loosen the 6 bolts in the order shown in the illustration.

  1. Lightly tap the cylinder head sub-assembly LH to separate it from the cylinder block (bank 2).

  1. Remove the cylinder head sub-assembly LH.

    NOTICE:
    Be careful not to scratch the mating surface of the cylinder head and cylinder block.



6. REMOVE NO. 2 CYLINDER HEAD GASKET
  1. Remove the No. 2 cylinder head gasket.