Home › Vehicle Exterior › BODY PANEL › FRONT FENDER APRON
BM2090E _01 Vehicle Exterior _060720 BODY PANEL _0297845 FRONT FENDER APRON F

BODY PANEL  FRONT FENDER APRON  ASSEMBLY REPLACEMENT  


K105344

With the front fender mounting bracket and front body pillar lower gusset removed.


REMOVAL


Symbol meaning
K108818

Remove Weld Points
K108820

Remove Weld Points
K108826

Cut with Disk Sander etc.


K139718

INSTALLATION


Symbol meaning
K108823

Plug Weld
K108825

Plug Weld
K108830

Fillet Weld


INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram)

3.

Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.

4.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)

5.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K139719E01
2.771,3.479 2.771,1.719 false 3.5,9.219 3.656,9.219 3.656,9.219 4.292,8.792 false 5.625,9.604 5.75,9.604 5.75,9.604 6.219,8.781 false 0.167,2.177 0.76,2.406 0.594,0.229 10 false 15 (0.59) 2.146,3 2.74,3.229 0.594,0.229 10 false 15 (0.59) 1.448,3.521 4.208,3.729 2.76,0.208 10 false FRONT FENDER APRON SUB-ASSEMBLY 3.792,6.771 4.229,7.031 0.438,0.26 12 false LHD: 3.771,6.979 4.146,7.219 0.375,0.24 12 false RH 5.406,6.76 5.833,7 0.427,0.24 12 false RHD: 5.427,6.979 5.802,7.219 0.375,0.24 12 false LH 0.854,9.115 3.5,9.354 2.646,0.24 10 false BATTERY CLAMP MOUNTING BRACKET 0.104,9.5 0.74,9.75 0.635,0.25 10 false mm (in.) 2.979,9.49 5.625,9.729 2.646,0.24 10 false BATTERY CLAMP MOUNTING BRACKET