Home › Vehicle Exterior › BODY PANEL › QUARTER PANEL END HOUSING
BM2090E _01 Vehicle Exterior _060720 BODY PANEL _0297855 QUARTER PANEL END HOUSING F

BODY PANEL  QUARTER PANEL END HOUSING  ASSEMBLY REPLACEMENT  


K105090

REMOVAL


Symbol meaning
K108818

Remove Weld Points
K108820

Remove Weld Points
K108827

Cut with Disc Sander etc.


REMOVAL POINT
1.

Cut the quarter panel and fold it upward as shown in *1. Then cut through the welded area of the quarter panel inner rear and quarter inner panel rear, and remove the quarter panel extension rear lower.


K139754E01
2.833,8.948 3,8.948 3,8.948 3.563,8.396 false 3.781,5.802 4.469,5.125 4.469,5.125 4.615,5.125 false 3.354,5.656 3.469,4.854 3.469,4.854 3.625,4.854 false 2.188,5.052 2.333,5.052 2.333,5.052 3.302,5.688 false 2.01,4.958 2.323,5.156 0.313,0.198 10 false *1 3.677,4.76 4.885,4.958 1.208,0.198 10 false QUARTER PANEL 4.708,5.021 6.979,5.24 2.271,0.219 10 false LH:QUARTER PANEL INNER REAR 4.698,5.292 7,5.49 2.302,0.198 10 false RH:QUARTER INNER PANEL REAR 0.823,8.854 2.844,9.073 2.021,0.219 10 false QUARTER PANEL EXTENSION 0.833,9.031 1.833,9.24 1,0.208 10 false REAR LOWER

INSTALLATION


Symbol meaning
K108823

Plug Weld
K108825

Plug Weld
K108831

Butt Weld


INSTALLATION POINT
1.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

2.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)

3.

After welding, apply body sealer to the corresponding parts. (See the painting / coating)

4.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K139755E01
3.167,2.052 3.667,1.594 3.667,1.594 3.885,1.594 false 3.958,1.5 6.021,1.698 2.063,0.198 10 false QUARTER PANEL EXTENSION 3.969,1.688 4.958,1.896 0.99,0.208 10 false REAR LOWER