With the body lower back panel removed.
REMOVAL
| Symbol meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut with Disc Sander etc. |
After removing the rear floor side panel and rear bumper bracket, remove the rear floor pan to quarter panel extension.
INSTALLATION
| Symbol meaning | |
|---|---|
|
Plug Weld |
|
Plug Weld |
|
Plug Weld |
When welding *1, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
After welding the rear floor pan to quarter panel extension to the vehicle side, install the rear floor side panel and rear bumper bracket.
After welding, apply body sealer to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.