With the body lower back panel removed.
REMOVAL
| Symbol meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut with Disc Sander etc. |
After removing the rear floor side panel and rear bumper bracket, remove the rear floor side member reinforcement sub-assembly rear.
INSTALLATION
| Symbol meaning | |
|---|---|
|
Plug Weld |
|
Plug Weld |
|
Plug Weld |
When welding *1, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
After welding the rear floor side member reinforcement sub-assembly rear to the vehicle side, install the rear floor side panel and rear bumper bracket.
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.