Home › Vehicle Exterior › BODY DIMENSIONS › REAR SUSPENSION CROSSMEMBER
BM2090E _01 Vehicle Exterior _060721 BODY DIMENSIONS _0297871 REAR SUSPENSION CROSSMEMBER F

BODY DIMENSIONS  REAR SUSPENSION CROSSMEMBER  TWO-DIMENSIONAL DISTANCE  


HINT:
·

Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

·

In cases in which only one dimension is given, left and right are symmetrical.


·

For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).



Measuring Point Name
Symbol Name Hole Diameter
mm (in.)
A, a Rear Suspension Crossmember Installation Hole φ60 (2.36)
B, b Rear Suspension Crossmember Standard Hole φ10 (0.39)
C, c Rear Suspension Lower Arm Installation Hole 14.5X25 (0.57X0.98)
D, d Rear Suspension Upper Arm Installation Hole φ13.5 (0.53)
E, e Rear Suspension Upper Arm Installation Hole φ13.5 (0.53)
F, f Rear Suspension Lower Arm Installation Hole φ12.5 (0.49)
G, g Rear Suspension Crossmember Installation Hole φ60 (2.36)

K139448E01
3.365,2.417 3.74,2.646 0.375,0.229 10 false Front 4.208,3.125 4.521,3.323 0.313,0.198 10 false RH 2.667,3.135 2.979,3.333 0.313,0.198 10 false LH 0.156,8.458 0.469,8.656 0.313,0.198 10 false mm 0.167,8.615 0.479,8.865 0.313,0.25 10 false (in.)

K139449E01
1.542,5.417 2.938,5.646 1.396,0.229 10 false Imaginary Datum Line 0.802,6.177 2.938,6.396 2.135,0.219 10 false Height from Imaginary Datum Line 0.146,8.448 0.458,8.646 0.313,0.198 10 false mm 0.156,8.604 0.469,8.833 0.313,0.229 10 false (in.)