Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM › from 2016.06
NM2090E _54 Brake _060637 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0297335 BRAKE CONTROL SYSTEM UN GENERAL/CONTROL/DETAILS F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM  GENERAL/CONTROL/DETAILS  GENERAL  


OUTLINE


a.

The following brake control functions are provided: Anti-lock Brake System (ABS), Electronic Brake force Distribution (EBD), brake assist, Traction Control (TRC), Vehicle Stability Control (VSC), Hill-start Assist Control.


b.

A VSC OFF switch (pattern select switch assembly) is used.


c.

TRACK switch (pattern select switch assembly) is used.


d.

If TRACK mode is selected, the timing of VSC control intervention is delayed and the amount of control is reduced. This increases the control range of the driver and enables sportier driving compared to Normal mode.


e.

An emergency brake signal is used. This signal is provided to indicate that strong braking is being performed by the driver.*

HINT:

*: Except Models for Korea




PRECAUTION


a.

Ignition Switch Expressions

i.

The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression Ignition Switch (Position) Engine Switch (Condition)
Ignition Switch off LOCK Off
Ignition Switch ACC ACC On (ACC)
Ignition Switch ON ON On (IG)
Engine Start START Start