| Radiator Cap | Pumping speed:
1 pump per second Standard valve (for brand-new cap): 93 to 123 kPa (0.95 to 1.25 kgf*cm2, 14 to 18 psi) Minimum standard valve (after suing cap): 83 kPa (0.85 kgf*cm2, 12 psi) |
| Thermostat (for Engine Coolant) | Valve opening temperature:
86 to 90°C (187 to 194°F) |
| Valve lift:
8.0 mm (0.315 in.) or more at 95°C (203°F) |
|
| Thermostat (for Automatic Transmission) | Valve opening temperature:
48 to 52°C (118 to 126°F) |
| Valve lift:
6.0 mm (0.236 in.) or more at 63°C (145°F) |
|
| Cooling fan motor | Standard current:
7.4 to 11.4 A at 20°C (68°F) (when the battery is connected to the fan motor connector) |
| No. 2 cooling fan motor
(w/ Air Conditioning System) |
Standard current:
7.4 to 11.4 A at 20°C (68°F) (when the battery is connected to the fan motor connector) |
| Fan No. 1 relay | Standard resistance (3 - 5): 10 kΩ or higher
(Battery voltage is not applied between terminals 1 and 2) Standard resistance (3 - 5): Below 1 Ω (Battery voltage is applied between terminals 1 and 2) |
| Fan No. 2 relay
(w/ Air Conditioning System) |
Standard resistance (3 - 4): Below 1 Ω
(Battery voltage is not applied between terminals 1 and 2) Standard resistance (3 - 5): 10 kΩ or higher (Battery voltage is not applied between terminals 1 and 2) Standard resistance (3 - 4): 10 kΩ or higher (Battery voltage is applied between terminals 1 and 2) Standard resistance (3 - 5): Below 1 Ω ( Battery voltage is applied between terminals 1 and 2) |
| Fan No. 3 relay
(w/ Air Conditioning System) |
Standard resistance (3 - 5): 10 kΩ or higher
(Battery voltage is not applied between terminals 1 and 2) Standard resistance (3 - 5): Below 1 Ω ((Battery voltage is not applied between terminals 1 and 2) |