Home › Engine / Hybrid System › FA20 (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE
RM2090E _51 Engine / Hybrid System _060665 FA20 ENGINE CONTROL _0297472 CAMSHAFT OIL CONTROL VALVE G

FA20 ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 15330 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE

a.

Connect the GTS to the DLC3.


b.

Start the engine.


c.

Turn the GTS on.


d.

Turn the A/C switch on.


e.

Inspect the camshaft timing oil control valve (for intake side).

i.

Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Linear (Bank 1).


ii.

Check the engine speed while operating the camshaft timing oil control valve assembly (for intake side of bank 1) using the GTS.

OK:
Tester Operation Specified Condition
0 deg (CA) Normal engine speed
36 deg (CA) Engine idles roughly or stalls


If the operation is not as specified, check the camshaft timing oil control valve, wire harness and ECM.


iii.

Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Linear (Bank 2).


iv.

Check the engine speed while operating the camshaft timing oil control valve assembly (for intake side of bank 2) using the GTS.

OK:
Tester Operation Specified Condition
0 deg (CA) Normal engine speed
36 deg (CA) Engine idles roughly or stalls


If the operation is not as specified, check the camshaft timing oil control valve, wire harness and ECM.



f.

Inspect the camshaft timing oil control valve (for exhaust side).

i.

Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Exhaust Linear (Bank 1).


ii.

Check the engine speed while operating the camshaft timing oil control valve assembly (for exhaust side of bank 1) using the GTS.

OK:
Tester Operation Specified Condition
0 deg (CA) Normal engine speed
51 deg (CA) Engine idles roughly or stalls


If the operation is not as specified, check the camshaft timing oil control valve, wire harness and ECM.


iii.

Enter the following menus: Powertrain / Engine / Active Test / Control the VVT Exhaust Linear (Bank 2).


iv.

Check the engine speed while operating the camshaft timing oil control valve assembly (for exhaust side of bank 2) using the GTS.

OK:
Tester Operation Specified Condition
0 deg (CA) Normal engine speed
51 deg (CA) Engine idles roughly or stalls


If the operation is not as specified, check the camshaft timing oil control valve, wire harness and ECM.