Home › Engine / Hybrid System › FA20 (ENGINE CONTROL) › MASS AIR FLOW METER
RM2090E _51 Engine / Hybrid System _060665 FA20 ENGINE CONTROL _0297476 MASS AIR FLOW METER G

FA20 ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.
A154164E22
0.896,2.042 1.146,0.948 true 1.146,0.75 1.354,1.094 0.208,0.344 10 false *1

Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

Text in Illustration
*1 Platinum Hot Wire (Heater)

OK:

There is no foreign matter.


If the result is not as specified, replace the mass air flow meter.


b.
A167890E14
0.271,0.24 0.427,0.417 0.156,0.177 10 false *a 1.958,1.438 2.115,1.615 0.156,0.177 10 false 1 1.813,1.438 1.969,1.615 0.156,0.177 10 false 2 1.656,1.438 1.813,1.615 0.156,0.177 10 false 3 1.5,1.438 1.656,1.615 0.156,0.177 10 false 4 1.344,1.438 1.5,1.615 0.156,0.177 10 false 5

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Component without harness connected
(Mass Air Flow Meter)

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.49 to 0.67 kΩ


If the resistance is not as specified, replace the mass air flow meter.