Home › Engine / Hybrid System › FA20 (ENGINE CONTROL) › ENGINE OIL TEMPERATURE SENSOR › from 2013.07
RM2090E _51 Engine / Hybrid System _060665 FA20 ENGINE CONTROL _0297481 ENGINE OIL TEMPERATURE SENSOR G

FA20 ENGINE CONTROL  ENGINE OIL TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE OIL TEMPERATURE SENSOR

A261060E02
5.552,1.208 5.948,0.74 true 4.146,0.177 4.354,0.427 0.208,0.25 10 false *a 6,0.594 6.25,0.844 0.25,0.25 10 false *c 6.594,2.302 7.094,2.479 0.5,0.177 10 false °C (°F) 4.604,0.135 4.927,0.344 0.323,0.208 8 false 30 4.604,0.26 4.927,0.469 0.323,0.208 8 false 20 4.604,0.469 4.927,0.677 0.323,0.208 8 false 10 4.604,0.719 4.927,0.927 0.323,0.208 8 false 5 4.604,0.885 4.927,1.094 0.323,0.208 8 false 3 4.604,1.042 4.927,1.25 0.323,0.208 8 false 2 4.604,1.24 4.927,1.448 0.323,0.208 8 false 1 4.604,1.792 4.927,2 0.323,0.208 8 false 0.2 4.604,1.656 4.927,1.865 0.323,0.208 8 false 0.3 4.604,1.49 4.927,1.698 0.323,0.208 8 false 0.5 4.604,2 4.927,2.208 0.323,0.208 8 false 0.1 5.125,2.313 5.271,2.49 0.146,0.177 8 false 0 5.333,2.313 5.521,2.5 0.188,0.188 8 false 20 5.583,2.313 5.76,2.5 0.177,0.188 8 false 40 5.833,2.313 6.01,2.479 0.177,0.167 8 false 60 6.083,2.313 6.25,2.469 0.167,0.156 8 false 80 6.313,2.313 6.563,2.479 0.25,0.167 8 false 100 4.823,2.313 5.042,2.49 0.219,0.177 8 false -20 4.542,2.323 4.771,2.552 0.229,0.229 10 false *b 4.823,2.469 5.031,2.677 0.208,0.208 8 false (-4) 5.052,2.469 5.313,2.667 0.26,0.198 8 false (32) 5.292,2.469 5.542,2.677 0.25,0.208 8 false (68) 5.521,2.469 5.833,2.646 0.313,0.177 8 false (104) 5.792,2.469 6.094,2.656 0.302,0.188 8 false (140) 6.083,2.469 6.396,2.667 0.313,0.198 8 false (176) 6.354,2.469 6.667,2.656 0.313,0.188 8 false (212) 4.573,0 4.833,0.156 0.26,0.156 10 false kΩ 1.615,0.188 1.844,0.385 0.229,0.198 10 false *d

Text in Illustration
*a Resistance *b Temperature
*c Acceptable *d Component without harness connected
(Engine oil Temperature Sensor)

a.

Partially soak the sensor in the water and warm up the water.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Approximately 20°C (68°F) 2.25 to 2.65 kΩ
Approximately 80°C (176°F) 0.305 to 0.331 kΩ


NOTICE:

When checking the engine oil temperature sensor in water, keep the terminals dry. After the check, wipe the engine oil temperature sensor dry.


If the result is not as specified, replace the engine oil temperature sensor.