Home › Engine / Hybrid System › FA20 (ENGINE MECHANICAL) › DRIVE BELT
RM2090E _51 Engine / Hybrid System _060666 FA20 ENGINE MECHANICAL _0297488 DRIVE BELT A

FA20 ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

A276034E01
0.884,0.533 1.058,0.707 0.174,0.174 10 *1 1.704,0.596 1.878,0.770 0.174,0.174 10 *1 2.016,0.815 2.190,0.989 0.174,0.174 10 *1 0.919,0.196 1.093,0.370 0.174,0.174 10 *2 0.837,1.193 1.011,1.367 0.174,0.174 10 *3 2.221,1.612 2.395,1.786 0.174,0.174 10 *4 1.589,1.14 1.763,1.314 0.174,0.174 10 *5 2.206,0.314 2.380,0.488 0.174,0.174 10 *6 1.193,1.027 1.038,1.247 false

a.

Set the fan and generator V belt onto every part.

Text in Illustration
*1 Idler
*2 Generator
*3 Tensioner
*4 Water Pump
*5 Crankshaft
*6 A/C Compressor (w/ Air Conditioning System)
Idler Pulley Bracket (w/o Air Conditioning System)


b.

While turning the belt tensioner clockwise, remove the 3 mm (0.118 in.) hexagon wrench.

NOTICE:

Make sure that the fan and generator V belt is properly installed to each pulley.



c.

Check that the fan and generator V belt fits properly in the ribbed grooves.

HINT:

Make sure to check by hand that the fan and generator V belt have not slipped out of the grooves on the bottom of the pulley.



Hide 27029A 2.INSTALL BELT GENERATOR COVER

a.

Install the belt generator cover with the 2 blots.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


b.

Engage the 2 wire harness clamps and install the wire harness to the belt generator cover.


Hide 27029 3.INSTALL GENERATOR COVER

a.

Install the generator cover with the 2 blots.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


Hide 17705 4.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

a.

Install the air cleaner cap with air cleaner hose with the 3 blots.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


b.

Install the air cleaner cap with air cleaner hose with the 2 hose clamps.

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)


c.

Connect the No. 2 ventilation hose.


d.

Connect the mass air flow meter connector.


e.

Engage the wire harness clamp and install the wire harness to the air cleaner cap.