1.DISCHARGE FUEL SYSTEM PRESSURE
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
17764D
3.REMOVE CHAMBER ASSEMBLY
89871
4.REMOVE INJECTOR DRIVER
23261A
5.REMOVE INJECTOR COVER (for Bank 1)
Disengage the 4 clamps and separate the wire harness from the injector cover (for bank 1).
Remove the 2 bolts and injector cover (for bank 1).
77259D
6.DISCONNECT NO. 1 FUEL HOSE (for Metal Type)
Using SST, disconnect the No. 1 fuel hose from the fuel delivery pipe sub-assembly (See page Engine / Hybrid System>FA20 FUEL>FUEL SYSTEM>PRECAUTION).
77419
7.DISCONNECT NO. 3 FUEL HOSE (for Metal Type)
Using SST, disconnect the No. 3 fuel hose from the fuel pipe (See page Engine / Hybrid System>FA20 FUEL>FUEL SYSTEM>PRECAUTION).
77279G
8.DISCONNECT NO. 2 FUEL HOSE (for Metal Type)
Remove the clamp and disconnect the No. 2 fuel vapor feed hose from the fuel pipe.
23261A
9.REMOVE INJECTOR COVER (for Bank 2)
Remove the bolt and disconnect the wire harness clamp bracket from the injector cover (for bank 2).
Remove the 2 bolts and injector cover (for bank 2).
77259D
10.DISCONNECT NO. 1 FUEL HOSE (for Clamp Type)
Remove the clamp and disconnect the No. 1 fuel hose.
Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
Be careful not to splash the fuel.
Receive the fuel remaining inside the fuel hose with a container.
Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
23807
11.SEPARATE FUEL DELIVERY PIPE SUB-ASSEMBLY (for Clamp Type)
Remove the bolt and disconnect the fuel delivery pipe sub-assembly.
Disconnect the No. 2 fuel vapor feed hose and move the fuel delivery pipe sub-assembly toward the front of the vehicle.
12.REMOVE FUEL DELIVERY PIPE (for Bank 2)
Disconnect the 2 fuel injector assembly connectors.
Disengage the clamp and separate the wire harness.
Disconnect the fuel pump assembly connector.
Disconnect the No. 2 fuel delivery pipe sub-assembly from the fuel delivery pipe (See page Engine / Hybrid System>FA20 FUEL>FUEL SYSTEM>PRECAUTION).
Remove the 2 bolts and fuel delivery pipe.
When removing the fuel delivery pipe, hold the pipe by both ends and pull it straight upward.
23255A
13.REMOVE FUEL INJECTOR SEAL (for Bank 2)
Remove the 2 fuel injector seals.
14.REMOVE FUEL DELIVERY PIPE (for Bank 1)
Disconnect the 2 fuel injector assembly connectors.
Disengage the clamp and separate the wire harness.
Disconnect the No. 2 fuel delivery pipe sub-assembly from the fuel delivery pipe (See page Engine / Hybrid System>FA20 FUEL>FUEL SYSTEM>PRECAUTION).
Remove the 2 bolts and fuel delivery pipe.
When removing the fuel delivery pipe, hold the pipe by both ends and pull it straight upward.
23255A
15.REMOVE FUEL INJECTOR SEAL (for Bank 1)
Remove the 2 fuel injector seals.
23250
16.REMOVE FUEL INJECTOR ASSEMBLY
Remove the 4 fuel injector assemblies from the fuel delivery pipe.
For reinstallation, attach a tag or label to the injector shaft.
Remove the fuel injector O-ring and fuel injector grommet from the fuel injector assembly.
| *1 | Fuel injector O-ring |
| *2 | Fuel injector grommet |