23250
1.INSPECT FUEL INJECTOR ASSEMBLY
This inspection aims is to inspect the fuel injectors for opens or shorts, because the fuel injectors of this vehicle are of a high-pressure type and cannot be inspected for fuel injection volume.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 1.9 Ω |
| *a | Component without harness connected
(Fuel Injector Assembly) |
If the result is not as specified, replace the fuel injector assembly.