Home › Engine / Hybrid System › FA20 FUEL › FUEL PRESSURE SENSOR › from 2016.06
RM2090E _51 Engine / Hybrid System _060667 FA20 FUEL _0297502 FUEL PRESSURE SENSOR G

FA20 FUEL  FUEL PRESSURE SENSOR  INSPECTION  


PROCEDURE

Hide 89458 1.INSPECT FUEL PRESSURE SENSOR

A392838E01
1.542,1.073 1.271,0.552 1.271,0.552 0.99,0.552 true 1.26,1.26 1.094,1.76 1.094,1.76 0.813,1.76 true 1.885,1.26 2.042,1.771 2.042,1.771 2.302,1.771 true 2.167,1.063 2.385,0.542 2.385,0.542 2.594,0.542 true 0.417,0.448 1.198,0.719 0.781,0.271 10 false VOUT1 0.469,1.708 1.25,1.979 0.781,0.271 10 false VCC 2.365,1.708 3.146,1.979 0.781,0.271 10 false GND 2.677,0.469 3.219,0.854 0.542,0.385 10 false VOUT2 0.115,0.094 0.896,0.365 0.781,0.271 10 false *a

a.

Check the fuel pressure sensor output voltage.

i.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
3 (VOUT1) - 2 (GND) Apply 5 V between terminals 4 (VCC) and 2 (GND) Approximately 0.5 V


Text in Illustration
*a Component without harness connected
(Fuel Pressure Sensor)

NOTICE:
·

Be careful when connecting the leads, as the fuel pressure sensor may be damaged if the leads are connected to the wrong terminals.

·

Do not apply a voltage of 6 V or more to the terminals 4 (VCC) and 2 (GND).



HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries, etc.


If the resistance is not as specified, replace the fuel pressure sensor.