Home › Engine / Hybrid System › FA20 FUEL › FUEL PUMP
RM2090E _51 Engine / Hybrid System _060667 FA20 FUEL _0297504 FUEL PUMP G

FA20 FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL PUMP ASSEMBLY

a.
A397758E01
1.323,1.417 1.521,0.906 false 2.135,1.417 1.917,0.917 false 0.073,0.073 0.26,0.292 0.188,0.219 10 false *a 1.26,1.417 1.375,1.604 0.115,0.188 10 false 1 2.125,1.406 2.24,1.594 0.115,0.188 10 false 2

Inspect the resistance of the fuel pump assembly.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


Text in Illustration
*a Component without harness connected
(Fuel Pump Assembly)

If the result is not as specified, replace the fuel pump assembly.



b.
A282938E01
0.103,0 0.259,0.181 0.156,0.181 10 *a

Inspect the operation of the fuel pump assembly.

i.

Connect a battery's negative (-) lead to terminal 3 of the connector, and a positive (+) lead to terminal 4. Check that the fuel pump operates.

Text in Illustration
*a Component without harness connected
(Fuel Suction Tube Assembly with Pump and Gauge)

NOTICE:
·

These tests must be performed within 10 seconds to prevent the coil from burning out.


·

Keep the fuel pump as far away from the battery as possible.


·

Always turn on and off the voltage on the battery side, and not on the fuel pump side.