Home › Engine / Hybrid System › FA20 EMISSION CONTROL › PURGE VALVE
RM2090E _51 Engine / Hybrid System _060668 FA20 EMISSION CONTROL _0297511 PURGE VALVE G

FA20 EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 17650 1.INSPECT PURGE VALVE

a.
A280551E02
0.833,0.708 0.646,1.375 true 1.01,0.708 1.042,1.375 true 0.583,1.396 0.74,1.573 0.156,0.177 10 false 1 1.021,1.406 1.177,1.583 0.156,0.177 10 false 2

Measure the resistance according to the value in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 21 to 27 Ω



b.
A280552E02
0.469,0.844 0.719,0.885 false 0.542,1.115 0.698,1.292 0.156,0.177 10 false *1 1.188,1.031 1.344,1.208 0.156,0.177 10 false *2 0.26,0.75 0.417,0.927 0.156,0.177 10 false *3

Check the operation of the purge valve.

i.

Install a clean hose to the purge valve.


ii.

Check that air does not flow from port E to port F.


iii.

Check that air flows from port E to port F.

Text in Illustration
*1 Port E
*2 Port F
*3 Clean Hose
V100135

Air

OK:
Measurement Condition Specified Condition
Battery does not connect Air does not flow from port E to port F
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Air flows from port E to port F


If the result is not as specified, replace the purge valve.


iv.

Remove the clean hose from the purge valve.