Home › Engine / Hybrid System › FA20 INTAKE / EXHAUST › INTAKE SYSTEM › from 2016.06
RM2090E _51 Engine / Hybrid System _060669 FA20 INTAKE / EXHAUST _0297514 INTAKE SYSTEM G

FA20 INTAKE / EXHAUST  INTAKE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT INTAKE SYSTEM

a.

Check that there is no air suction at the points shown in the illustration.

A392836E02
3.708,0.208 4.313,0.625 0.604,0.417 12 false *B 0.375,0.208 0.979,0.625 0.604,0.417 12 false *A

U190153E01
0.243,0.187 0.872,0.624 0.628,0.436 12 *C

Text in Illustration
*A for Manual Transmission (Aluminum Intake Manifold) *B for Manual Transmission (Resin Intake Manifold)
*C for Automatic Transmission - -
V100135

Check points
V100136

Forward

NOTICE:

Disengagement, cracks or damage in the intake component may cause an idling defect.



Hide 17801 2.INSPECT AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

a.
A280963

Disengage the 2 clips.


b.
A282907

Lift the rear air cleaner case, and disengage the 2 claws.


c.
A280964

Lift the rear air cleaner case as shown in the illustration, and remove the air cleaner filter element sub-assembly.


d.

Check that the air cleaner element is moderately clean.

Standard air cleaner element condition:

Not too dirty.


NOTICE:

If the element is too dirty, replace the air cleaner filter element.



e.

Use compressed air if the air cleaner filter element needs to be cleaned.


f.

Lift the rear air cleaner case, and install the air cleaner filter element sub-assembly.


g.

Engage the 2 claws.


h.
A282908E02
1.333,1.229 1.927,1.823 true 2.021,4.417 2.552,3.688 true 1.958,1.833 2.115,2.01 0.156,0.177 10 false *1 1.844,4.396 2,4.573 0.156,0.177 10 false *1

Engage the 2 clips.

NOTICE:
·

Securely engage the lower side claws of the air cleaner case.

·

Check if the right and left locating lugs of the air cleaner case do not get into the opposite air cleaner case.



Text in Illustration
*1 Locating Lugs