Home › Engine / Hybrid System › FA20 INTAKE / EXHAUST › INTAKE MANIFOLD › 2012.03–2016.06
RM2090E _51 Engine / Hybrid System _060669 FA20 INTAKE / EXHAUST _0297515 INTAKE MANIFOLD A

FA20 INTAKE / EXHAUST  INTAKE MANIFOLD  REASSEMBLY  


PROCEDURE

Hide 23808 1.INSTALL NO. 2 FUEL DELIVERY PIPE SUB-ASSEMBLY

a.
A280276

Install the No. 2 fuel delivery pipe sub-assembly to the intake manifold with the 3 clamps.


Hide 2.INSTALL FUEL DELIVERY PIPE (for Bank 2)

a.

Apply a gasoline to the contact surfaces of the new O-ring on each fuel injector assembly.


b.

Install a new O-ring to each fuel injector assembly.


c.

Install the fuel injector assembly to the intake manifold with fuel delivery pipe.

NOTICE:
·

Do not damage the fuel injector assembly or the O-ring.

·

Do not twist the O-ring.




d.
A282921

Install the fuel delivery pipe with the 2 bolts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


e.

Check that the fuel injectors rotate smoothly.

NOTICE:

If the fuel injectors do not rotate smoothly, the probable cause is incorrect installation of the O-rings. Replace the O-rings.



f.

Position the fuel injector connector outward.


Hide 3.INSTALL FUEL DELIVERY PIPE (for Bank 1)

HINT:

Use the same procedure described for the fuel delivery pipe (for bank 2).


Hide 55434E 4.INSTALL CAP (for Automatic Transmission)

a.
A285063

Install the cap to the intake manifold.


Hide 17650 5.INSTALL PURGE VALVE

a.
A281119

Connect the No. 1 fuel vapor feed hose to the intake manifold.


b.
A281117

Install the nut and purge valve to the intake manifold.

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)


Hide 89420M 6.INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR

a.

Apply engine oil to the contact surfaces of the new O-ring on manifold absolute pressure sensor.


b.
A276541

Install a new O-ring to the manifold absolute pressure sensor.


c.
A281145

Install the manifold absolute pressure sensor to the intake manifold with the bolt.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)