Home › Engine / Hybrid System › FA20 STARTING › ENGINE SWITCH
RM2090E _51 Engine / Hybrid System _060672 FA20 STARTING _0297533 ENGINE SWITCH G

FA20 STARTING  ENGINE SWITCH  INSPECTION  


PROCEDURE

Hide 89611 1.INSPECT ENGINE SWITCH

a.
A280257E02
1.396,0.99 0.76,0.771 true 2.083,0.99 2.719,0.771 true 2.406,1.688 2.104,1.344 true 1.531,1.698 1.583,1.354 true 0.146,0.156 0.302,0.313 0.156,0.156 10 false *a 2.771,0.698 3.229,0.854 0.458,0.156 10 false SSW2 0.313,0.677 0.813,0.833 0.5,0.156 10 false SSW1 1.354,1.719 1.854,1.885 0.5,0.167 10 false SWIL 2.302,1.708 2.948,1.865 0.646,0.156 10 false AGND

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (SSW1) - 6 (AGND) Pushed Below 1 Ω
1 (SSW2) - 6 (AGND) Pushed Below 1 Ω
5 (SSW1) - 6 (AGND) Not pushed 10 kΩ or higher
1 (SSW2) - 6 (AGND) Not pushed 10 kΩ or higher


If the result is not as specified, replace the engine switch.


b.

Apply battery voltage to the terminals of the switch and check the illumination condition of the switch.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (AGND)
Illuminates


If the result is not as specified, replace the engine switch.

Text in Illustration
*a Component without harness connected
(Engine Switch)