Home › Engine / Hybrid System › FA20 STARTING › IGNITION SWITCH
RM2090E _51 Engine / Hybrid System _060672 FA20 STARTING _0297534 IGNITION SWITCH G

FA20 STARTING  IGNITION SWITCH  INSPECTION  


PROCEDURE

Hide 84450 1.INSPECT IGNITION OR STARTER SWITCH ASSEMBLY

a.
A281434E03
2.438,1.063 2.052,0.302 true 2.625,1.063 2.448,0.302 true 2.792,1.063 2.792,0.302 true 2.979,1.063 3.229,0.302 true 2.99,1.75 2.802,1.427 true 2.573,1.74 2.615,1.417 true 2.167,1.75 2.427,1.427 true 0.094,0.073 0.25,0.229 0.156,0.156 10 false *a 0.802,0.125 1.219,0.323 0.417,0.198 10 false LOCK 1.542,0.406 1.885,0.604 0.344,0.198 10 false ACC 1.677,0.813 1.969,1 0.292,0.188 10 false ON 1.552,1.229 2.042,1.417 0.49,0.188 10 false START 1.875,0.115 2.156,0.292 0.281,0.177 10 false IG1 2.25,0.115 2.573,0.302 0.323,0.188 10 false ACC 2.458,1.771 2.781,1.948 0.323,0.177 10 false AM2 2,1.771 2.302,1.938 0.302,0.167 10 false ST2 2.667,0.115 2.99,0.292 0.323,0.177 10 false AM1 2.927,1.76 3.198,1.938 0.271,0.177 10 false IG2 3.073,0.115 3.365,0.281 0.292,0.167 10 false ST1

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
All combinations of all terminals LOCK 10 kΩ or higher
2 (AM2) - 3 (ACC) ACC Below 1 Ω
2 (AM2) - 3 (ACC) - 4 (IG1)
6 (IG2) - 7 (AM1)
ON Below 1 Ω
1 (ST1) - 2 (AM2) - 4 (IG1)
6 (IG2) - 7 (AM1) - 8 (ST2)
START Below 1 Ω


Text in Illustration
*a Component without harness connected
(Ignition or starter Switch Assembly)

If the result is not as specified, replace the ignition or starter switch assembly.